Mazda6 Performance Parts : Suspension Spring Sets

 : Suspension - Spring Sets : Spring Set 03-08 Mazda 6i

Spring Set
03-08 Mazda 6i

Part Number: 70019

Price: $280.15

Qty:

Addtional Photos - Select to Enlarge

Spring Set
03-08 Mazda 6i

Mazda 6i Spring Set - 2.3 liter 4-Cylinder Engine - Complete Set of Four (4) - Front & Rear

Over the years, Racing Beat has designed suspension coil springs that are suitable for a variety of street, autocross, and Solo applications. For the Mazda 6i application, our springs interchange exactly with the stock springs and can be used for both street or track applications. These springs have been designed with a modest rate increase of 20%, and will lower the car .75-inch front, and .50-inch rear. Our Mazda 6 springs have a rate of 251 lb/in front, and 168 lb/in rear.

Finished with a brilliant Racing Beat Red powder-coat paint, these springs for the Mazda 6 application will offer the motoring enthusiast years of handling performance.

Jim Mederer, Racing Beat's co-founder and chief engineer, offers the following insight to Racing Beat's philosophy on Mazda 6 suspension spring development:

"Springs are very much a mater of opinion, we adjust ride height and spring rate based more than any other thing on our personal opinion. We won't "slam", or excessively lower the Mazda 6 or any car strictly for appearance sake. First the car will hit the bump rubbers far too often and that makes the car unpredictable in its handling, also it offers a jarring ride and it is very harsh on suspension components causing them to potentially fail. We therefore make relatively small changes in ride height, usually less than 1". We adjust that based in part on what we perceive the best way of adjusting for good handling. Our primary goal in lowering the Mazda 6 is handling, and from our point a view, improved appearance is a side benefit. We don't lower the car for appearance, and then take what comes in handling. We are very cautious to not excessively lower the car such that it will cause perceived problems either in safety or unreasonable changes in ride comfort."

Note: All lowering figures are approximate. Actual lowering height may vary slightly from vehicle to vehicle and can be affected by differing OEM equipment packages and the installation of optional equipment.

Prices shown are for a complete set of four springs: 

2 x 70012 front springs

2 x 70013 rear springs

Prop65Warning

Customers who bought the above item also often bought:

Prothane Super Grease

Prothane Super Grease

We offer packets of Prothane Super Grease for use on any urethane bushing component. These are same packets that we supply with our sway bar kits. Each packet can be used to lubricate at least one sway bar. Price is for one (1) pack. »more
Price: $4.00 ADD »

Go to Racing Beat Home Page
Select: Go to Shopping Cart