2006-2014 Mazda MX5 Performance Parts : Suspension Spring Sets

 : Suspension - Spring Sets : Suspension Spring Set 06-08 MX-5

Suspension Spring Set
06-08 MX-5

Part Number: 54086

Price: $199.00

Qty:

Suspension Spring Set - 06-08 MX-5 - Detail 1Suspension Spring Set - 06-08 MX-5 - Detail 2

Addtional Photos - Select to Enlarge

Facebook Share

Suspension Spring Set
06-08 MX-5

Racing Beat Suspension Springs
MX-5 Miata - Soft Top Model - Set of Four

Racing Beat has designed suspension coil springs for the MX-5 Miata that are suitable for street or track use. This complete set of front and rear suspension springs were designed specifically for the MX-5 Miata by Racing Beat's engineering staff. Ideally suited for use with the stock Mazda shocks the Racing Beat springs will interchange exactly with the stock springs.

These springs have been designed with a rate increase of approximately 25% (front - 145 lb/in) and 25% (rear - 112 lb/in) with a modest drop of .5-inch (front & rear). (As compared to a Miata equipped with a manual transmission.)

Jim Mederer, Racing Beat's chief engineer, shares his design philosophy with regards to the development of suspension springs as follows. "Springs are very much a matter of opinion, I adjust ride height and spring rate based more than on any other thing, my taste. We won't excessively lower a car to obtain a "look". First the car will hit the bump rubbers far too often and that makes the car unpredictable in its handling, also it makes it harsh and it is very hard on suspension components causing them to potentially fail. We therefore make relatively small changes in ride height, usually less than 1", depending on the application. We adjust that based in part on what we perceive the best way of adjusting for good handling."

"Our primary goal in lowering the car is handling, and from our point a view, improved appearance is a side benefit. We don't lower the car for appearance, and then take what comes in handling. We are very cautious to not excessively lower the car such that it will cause perceived problems either in safety, excessive tire wear, or unreasonable changes in ride comfort."

For information on the correct method to shorten the "bump rubbers" when installing these springs, click here.(PDF)

Customers who bought the above item also often bought:

Cold Force Intake Kit - Rally Red - 06-11 MX-5

Cold Force Intake Kit - Rally Red - 06-11 MX-5

Cold Force MX-5 Intake for 2006-2011 Models (Rally Red Intake Tube) - Racing Beat introduces the Cold Force Intake for the MX-5 Miata. Designed to utilize the full benefit of a cold air ram effect, the Cold Force Intake System allows pressurized,... Cold Force Intake Kit - Rally Red - 06-11 MX-5

Power Pulse MX-5 Exhaust - 06-08 MX-5

Power Pulse MX-5 Exhaust - 06-08 MX-5

MX-5 Stainless Steel Power Pulse Muffler - If you're like most Miata MX-5 enthusiasts, one of the first upgrades that you're likely to consider for your car is an upgraded exhaust system. For the earlier 1990-2005 Miata we found that many of... Power Pulse MX-5 Exhaust - 06-08 MX-5

Sway Bar Package - 06-14 MX-5

Sway Bar Package - 06-14 MX-5

Sway bar set for 2006-2014 MX-5 - Racing Beat-designed tubular sway bars reduce chassis roll during cornering and increases your car's sensitivity to steering inputs, thereby improving maximum cornering power. Substantial engineering effort,... Sway Bar Package - 06-14 MX-5

Go to Racing Beat Home Page
Select: Go to Shopping Cart