Early Rotary & 1979-85 Mazda RX-7 : Oil System

 : Oil System : Oil Line Set RX-2, RX3 & RX-4

Oil Line Set
RX-2, RX3 & RX-4

Part Number: 11906

Price: $145.00

Qty:

Oil Line Set - RX-2, RX3 & RX-4 - Detail 1

Addtional Photos - Select to Enlarge

Facebook Share

Oil Line Set
RX-2, RX3 & RX-4

Racing Beat's fully assembled Stainless Steel Braided Hose Sets for the RX-2, RX-3, and RX-4 chassis replace the original factory oil cooler hoses. Significantly less costly than the Mazda replacement units, the Racing Beat-designed oil hose sets will easily meet the demands of street and most race applications.

Produced from Earl's Perform-O-Flex stainless steel braid-protected synthetic rubber hose and featuring an inner liner of synthetic rubber, including partial cover of stainless steel braid embedded into the liner during manufacturing. The hose liner is then bonded to a outer protective sheath of stainless steel wire braid. Precision-machined aluminum Swivel-Seal hose ends ensure a secure and superior seal. Each oil line set is carefully assembled and tested by Racing Beat to ensure top-notch quality, reliability and performance.

Racing Beat's oil line sets are a direct replacement for the original factory lines - no cutting or refitting is required! Select from the adaptor fittings listed below to correctly install your oil hoses onto your chassis.

Required Adaptor Fittings:
1971-85 engines -
Part No. 11901 (3 required)
Part No. 11902 (1 required)

Assembled in the USA by Racing Beat, Inc.Assembled in the USA by Racing Beat, Inc.

Customers who bought the above item also often bought:

Oil Hose Adapter Fitting - 16MM to -10 Hose

Oil Hose Adapter Fitting - 16MM to -10 Hose

We offer the Racing Beat Oil Cooler Hose Adapter Fittings to simplify oil system plumbing. These fittings adapt the 16mm female metric threads in the front cover (1971-95 rotary engines) and oil cooler (1971-85 stock or factory race) to accept -10... Oil Hose Adapter Fitting - 16MM to -10 Hose

Transmission Throwout Bearing - Pre-79 12A & 13B

Transmission Throwout Bearing - Pre-79 12A & 13B

The Transmission Throwout Bearing Retaining Spring is required to secure the throwout bearing on pre 1979 12A & 13B applications. Transmission Throwout Bearing - Pre-79 12A & 13B

Type I Modified Stationary Gear - 13B Rear-Groove

Type I Modified Stationary Gear - 13B Rear-Groove

Our Racing Beat Type I Modified 13B Rear (Special-Grooved) Stationary Gears are strongly recommended for engines which are regularly running near or above 8,500 RPM. These gears have had several machining modifications performed, as well as... Type I Modified Stationary Gear - 13B Rear-Groove

Transmission Seal Kit - 74-78 Trans (All)

Transmission Seal Kit - 74-78 Trans (All)

We recommend replacing the transmission front seal and rear seal kit when re-installing the transmission to reduce the risk of leakage. The primary reason for leaks seems to be the large loads that are placed on the input shaft when re-installing... Transmission Seal Kit - 74-78 Trans (All)

Go to Racing Beat Home Page
Select: Go to Shopping Cart