Oil Line Set
RX-2, RX3 & RX-4

Part Number: 11906

Price: $145.00

Qty:

Addtional Photos - Select to Enlarge

Oil Line Set
RX-2, RX3 & RX-4

Instruction Manual

Racing Beat's fully assembled Stainless Steel Braided Hose Sets for the RX-2, RX-3, and RX-4 chassis replace the original factory oil cooler hoses. Significantly less costly than the Mazda replacement units, the Racing Beat-designed oil hose sets will easily meet the demands of street and most race applications.

Produced from Earl's Perform-O-Flex stainless steel braid-protected synthetic rubber hose and featuring an inner liner of synthetic rubber, including partial cover of stainless steel braid embedded into the liner during manufacturing. The hose liner is then bonded to a outer protective sheath of stainless steel wire braid. Precision-machined aluminum Swivel-Seal hose ends ensure a secure and superior seal. Each oil line set is carefully assembled and tested by Racing Beat to ensure top-notch quality, reliability and performance.

Racing Beat's oil line sets are a direct replacement for the original factory lines - no cutting or refitting is required! Select from the adaptor fittings listed below to correctly install your oil hoses onto your chassis.

Required Adaptor Fittings:
1971-85 engines -
Part No. 11901 (3 required)
Part No. 11902 (1 required)

Assembled in the USA by Racing Beat, Inc.