Early Rotary & 1979-85 Mazda RX-7 : Ring & Pinion Differential

 : Ring & Pinion - Differential : Ring and Pinion Gear Set 4.444 Ratio

Ring and Pinion Gear Set
4.444 Ratio

Part Number: 13005

Price: $680.00

See below for special ordering options
and instructions.

Ring and Pinion Gear Set - 4.444 Ratio - Detail 1

Addtional Photos - Select to Enlarge

Facebook Share

Ring and Pinion Gear Set
4.444 Ratio

The Mazda 4.444 ratio ring and pinion set is suitable use on the following rotary and Miata Applications: RX-2, RX-3 SP, 1979-85 RX-7, and the 1994-01 Miata.

Alternate axle ratios are available for special applications. These ratios interchange exactly with the stock parts and should be adjusted to stock specifications (except as noted on the information sheet supplied with the gear set). If you replace your existing gear set with a lower ratio (higher number) gear set you will increase the vehicle's acceleration and move through the transmission gears quicker, but you will simultaneously reduce the top speed of the vehicle for a given rpm limit. However, if you reduce your existing gear set with a higher ratio (lower number) gear set you will decrease the vehicle's acceleration and move slower through the gears, but the top speed of the vehicle will increase for the same given rpm limit as in the previous example.

Note that the RX-3 SP uses the same gear sets as the RX-2 and RX-7, while other models of the RX-3 have a different selection of gears. The pinion shaft is longer on the conventional RX-3.

THIS PART CANNOT BE RETURNED FOR EXCHANGE OR REFUND DUE TO ITS FRAGILE NATURE AND POSSIBLE CUSTOMER MISHANDLING 

Genuine Mazda PartGenuine Mazda Part.

Customers who bought the above item also often bought:

Crush Tube  - 1971-85 Rotary ALL

Crush Tube - 1971-85 Rotary ALL

We have available the Mazda OEM Crush Tube for all 1971-85 Rotary differentials (1 required). When replacing the pinion in any differential, it is wise to replace the pinion bearings, locknut and seal, and mandatory to change the crush tube.... Crush Tube  - 1971-85 Rotary ALL
" rel="nofollow">

Road Race Header Outlet Gasket

Road Race Header Outlet Gasket

Flange & Gasket Guide

Flange & Gasket Guide

Use this illustrated guide to select the exact flange and/or gasket for your application.

Racing Beat's Road Race Header - Outlet Gasket
This gasket is intended for use with the outlet flange of the Racing Beat Road Race header (one required). This... Road Race Header Outlet Gasket
" rel="nofollow">

Road Race Header - Outlet Flange - Steel

Road Race Header - Outlet Flange - Steel

Flange & Gasket Guide

Flange & Gasket Guide

Use this illustrated guide to select the exact flange and/or gasket for your application.

This laser-cut flange can be used to fabricate a custom exhaust for use with the Racing Beat Road/Race Header. This two-hole flange measures 6" X 2-13/16" and features two 2"... Road Race Header - Outlet Flange - Steel
" rel="nofollow">

Disassembled Road Race Header Kit  - 13B engines

Disassembled Road Race Header Kit - 13B engines

We offer a Disassembled Road Race Header Kit for customized exhausts or special chassis clearance requirements. Both the 12A and 13B engine kits include: an engine-to-header flange, primary tube #1 and primary tube #2, a U-bend tube section, and an... Disassembled Road Race Header Kit  - 13B engines
" rel="nofollow">

Go to Racing Beat Home Page
Select: Go to Shopping Cart