Early Rotary & 1979-85 Mazda RX-7 :

 :  : Adjustable Front Lower Control Arms 79-85 RX-7

Adjustable Front Lower Control Arms
79-85 RX-7

Part Number: 14006

Price: $650.00

Qty:

Adjustable Front Lower Control Arms - 79-85 RX-7 - Detail 1Adjustable Front Lower Control Arms - 79-85 RX-7 - Detail 2

Addtional Photos - Select to Enlarge

Facebook Share

Adjustable Front Lower Control Arms
79-85 RX-7

RX-7 Adjustable Front Lower Control Arms add a new dimension of adjustability to your car. In order to get the most from your 1979-1985 RX-7's chassis, you need camber adjustability. Racers know that even with moderate size radial tires, it is possible to get improved front cornering power by increasing the camber to four or five degrees. While tire wear at this setting is high, the camber can be changed quite easily after initial setup with this kit, adjusting from race to street setting easily. This kit also allows you to correct an error in your chassis, or to pre-set incremental negative camber for better handling all the time (we recommend .5 degrees negative camber maximum for continuous use).

These arms can be shortened up to .5-inch from stock (approximately 1.3 degrees more positive camber than stock) or lengthened up to 1.625-inches from stock (approximately 4.4 degrees more negative camber than stock). The original rubber inner joint is retained to isolate road shocks and noise.

When front wheel negative camber is increased with this kit, there is a possibility that the front tire may contact the fender under some combination of bump and turn. This is especially true if wider-than stock wheels and tires are fitted. It is the user's responsibility to determine that there is adequate clearance for his application.

Price is for a pair.

Assembled in the USA by Racing Beat, Inc.Assembled in the USA by Racing Beat, Inc.

Customers who bought the above item also often bought:

Prothane Super Grease

Prothane Super Grease

We offer packets of Prothane Super Grease for use on any urethane bushing component. These are same packets that we supply with our sway bar kits. Each packet can be used to lubricate at least one sway bar. Price is for one (1) pack.

Prothane Super Grease

Distributor Cap - 80-85 RX-7

Distributor Cap - 80-85 RX-7

We offer the genuine Mazda distributor cap for use on 1980-85 (all) electronic distributors. The Mazda part number for this cap is listed as 8245-24-310B-9U. If needed, the distributor rotor is also available.

Distributor Cap - 80-85 RX-7

Racing Beat Rear Sway Bar Bushing - 79-85 RX-7

Racing Beat Rear Sway Bar Bushing - 79-85 RX-7

These urethane bushings are offered as direct replacements for the bushings that were originally supplied with the Racing Beat rear sway bar for the 1979-85 RX-7. Check the chart below for your specific application and part number.... Racing Beat Rear Sway Bar Bushing - 79-85 RX-7

Tokico Strut Illumina - Rear - 79-85 RX-7

Tokico Strut Illumina - Rear - 79-85 RX-7

1979-85 RX-7 Rear - Tokico IILLUMINA Strut Cartridge (BE-2317) - Tokico is one of the world's largest manufacturers of shock absorbers for both original equipment and high performance applications. As demand for shocks for the early 1979-85 RX-7... Tokico Strut Illumina - Rear - 79-85 RX-7

Go to Racing Beat Home Page
Select: Go to Shopping Cart