Early Rotary & 1979-85 Mazda RX-7 : Intake Weber

 : Intake - Weber : Weber Carb Base/Phenolic Spacer Gasket

Weber Carb Base/Phenolic Spacer Gasket

Part Number: 16487

Price: $5.00

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

Weber Carb Base/Phenolic Spacer Gasket

The Weber Carburetor Base and Phenolic Spacer Gaskets are used at the base of the carburetor, or on either side of the phenolic spacer. Sold individually, order the quantity required for your specific application. (Note: Two gaskets per manifold are required if phenolic spacers are NOT used, four (4) gaskets are required per manifold if phenolic spacers are used. Additional phenolic spacers require additional gaskets.)

Customers who bought the above item also often bought:

Phenolic Intake Spacers - 48 IDA & 51 Weber IDA Carb

Phenolic Intake Spacers - 48 IDA & 51 Weber IDA Carb

The Weber 48/51 IDA Phenolic Intake Spacers can be installed under a 48/51 IDA carburetor to increase the intake manifold length for special applications. Test have shown that up to three spacers per barrel can be used to move the torque peak down... Phenolic Intake Spacers - 48 IDA & 51 Weber IDA Carb

Weber Intake Manifold 48/51IDA - 84-85 13B 6-Port

Weber Intake Manifold 48/51IDA - 84-85 13B 6-Port

The Racing Beat-designed and manufactured cast-aluminum intake manifold is intended for use on a 1984-85 13B 6-Port engine with a Weber 48 IDA or the Racing Beat-modified 51 IDA carburetor (additional porting required).

These optional... Weber Intake Manifold 48/51IDA - 84-85 13B 6-Port

Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

The Accelerator Cable Linkage (Bell Crank), compatible with the Weber 48IDA and 51 IDA carburetors, is intended for Left-Hand drive rotary chassis using a Left-Hand drive-configured manifold. This linkage mounts to the end of the throttle shaft and... Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

Intake Gasket - 84-85 13B Engine-to-Manifold

Intake Gasket - 84-85 13B Engine-to-Manifold

The 1984-85 13B Engine-to-Manifold Mazda Factory gasket is intended to fit securely between the intake manifold and the engine.

If you are installing a Racing Beat Holley or Dellorto intake manifold, two (2) Intake Gasket - 84-85 13B Engine-to-Manifold

Go to Racing Beat Home Page
Select: Go to Shopping Cart