Early Rotary & 1979-85 Mazda RX-7 : Intake Weber

 : Intake - Weber : Phenolic Intake Spacers 48 IDA & 51 Weber IDA Carb

Phenolic Intake Spacers
48 IDA & 51 Weber IDA Carb

Part Number: 16621

Price: $16.50

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

Phenolic Intake Spacers
48 IDA & 51 Weber IDA Carb

The Weber 48/51 IDA Phenolic Intake Spacers can be installed under a 48/51 IDA carburetor to increase the intake manifold length for special applications. Test have shown that up to three spacers per barrel can be used to move the torque peak down about 300 to 500 RPM per spacer. Each spacer is 10mm thick. Two spacers are required, sold individually. Gaskets are not included, but are available separately.

Made in the USAMade in the USA by Racing Beat, Inc.

Customers who bought the above item also often bought:

Weber Carb Base/Phenolic Spacer Gasket

Weber Carb Base/Phenolic Spacer Gasket

The Weber Carburetor Base and Phenolic Spacer Gaskets are used at the base of the carburetor, or on either side of the phenolic spacer. Sold individually, order the quantity required for your specific application. (Note: Two gaskets per manifold are... Weber Carb Base/Phenolic Spacer Gasket

Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

The Accelerator Cable Linkage (Bell Crank), compatible with the Weber 48IDA and 51 IDA carburetors, is intended for Left-Hand drive rotary chassis using a Left-Hand drive-configured manifold. This linkage mounts to the end of the throttle shaft and... Accelerator Cable Linkage - 48/51 IDA(Bell Crank)

Weber Carburetor - 48 IDA Down Draft

Weber Carburetor - 48 IDA Down Draft

Both the elegant design and the simplicity in the maintenance of the Weber 48 IDA Carburetor have proven to be compelling reasons as to why the Weber name has remained so popular over the years. This Weber 48 IDA unit is primarily suited for various... Weber Carburetor - 48 IDA Down Draft

Intake Gasket - Engine-to-Manifold - 74-5/ 81-85 12A

Intake Gasket - Engine-to-Manifold - 74-5/ 81-85 12A

The 1974-75 and 1981-85 12A Engine-to-Manifold Mazda Factory gasket is intended to fit securely between the intake manifold and the engine. (Photo shown is of actual gasket) If you are installing a Racing Beat Holley or Dellorto intake manifold,... Intake Gasket - Engine-to-Manifold - 74-5/ 81-85 12A

Go to Racing Beat Home Page
Select: Go to Shopping Cart