Early Rotary & 1979-85 Mazda RX-7 : Intake Weber

 : Intake - Weber : K/N Filter Recharger Kit

K/N Filter Recharger Kit

Part Number: 55019.1

Price: $12.00

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

K/N Filter Recharger Kit

The K&N Recharger Kit is designed to clean and re-oil any K&N filter. A two-step process is used to clean and re-oil the filter for repeated use. Simply remove the filter element from the car, spray on the cleaning solution, let sit for a few minutes, then rinse under cold water. Let the filter sit for a couple more minutes to drain off any excess water, then reapply oil to the filter. (FYI -The oil is the source of the "red" color of the K&N filter, not the cotton mesh material.) Drop the filter back into the car and you're ready to go!

Routine use of this kit will extend the life of your K&N filter almost indefinitely. This kit comes complete with detailed step-by-step instructions and enough cleansing solution and oil for several cleaning cycles.

Authorized K&N Filter Dealer

Customers who bought the above item also often bought:

Racing Beat License Plate Frame

Racing Beat License Plate Frame

This Racing Beat logo license plate frame will look good on any Mazda vehicle! Constructed from heavy gauge plastic, this economical plate frame is the perfect addition to your vehicle. Racing Beat License Plate Frame

K/N Air Filter Element - 74-85 (except GSL-SE)

K/N Air Filter Element - 74-85 (except GSL-SE)

The K&N Air Filter Element, intended for all 1974-85 12A and 13B chassis (K&N E-2700)  (Except 13B GSL-SE ) interchanges exactly with the stock paper element. It is constructed with cotton gauze material sandwiched between fine wire... K/N Air Filter Element - 74-85 (except GSL-SE)

Intake Gasket - Engine-to-Manifold - 76-80 12A

Intake Gasket - Engine-to-Manifold - 76-80 12A

The 1976-80 12A Engine-to-Manifold Mazda Factory gasket is intended to fit securely between the intake manifold and the engine. (Photo shown is of actual gasket) If you are installing a Racing Beat Holley or Dellorto intake manifold, two (2) Water... Intake Gasket - Engine-to-Manifold - 76-80 12A

Heater Water Outlet Plug - 81-earlier rotary engines

Heater Water Outlet Plug - 81-earlier rotary engines

This Heater-Water-Outlet Plug is an inexpensive and reliable way to plug the heater water outlet port on the rear rotor housing for those who do not use a heater. The 1981 and earlier rotary engines had a threaded fitting for the water outlet that... Heater Water Outlet Plug - 81-earlier rotary engines

Go to Racing Beat Home Page
Select: Go to Shopping Cart