The 6-Puck 240mm Sport/Race Clutch Disc for the 1987-95 RX-7 TURBO & RX-8 chassis is designed for road race and occasional drag race use. The disc features six (6) sintered copper pucks and a sprung hub for a quick, positive engagement. The quick engagement/disengagement requires careful driver attention - this disc is not recommended for street use. This disc interchanges exactly with the stock disc and can be used with the stock pressure plate.
As with all of our clutch products, it is built only from new parts.
Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage.
WARNING: None of the Flywheel or Clutch components shown in this catalog should ever be allowed to exceed 10,500 RPM under any condition. This same RPM limit applies to stock components. You must use an engine RPM-limiter to prevent excessive RPM. If your RX-7 engine is capable of exceeding 8,500 RPM (or 9,000 RPM for the RX-8 Renesis engine) you must install a transmission scatter shield, or ballistic blanket. Failure to implement the above may result in serious injury or even death.