1986-92 Mazda RX-7 Performance Parts : Clutch/Pressure Plate

 : Clutch/Pressure Plate : Race Disc - 225mm 4-Puck TURBO Hub Spline

Race Disc - 225mm 4-Puck
TURBO Hub Spline

Part Number: 12525

Price: $122.00

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

Race Disc - 225mm 4-Puck
TURBO Hub Spline

This special application 4-Puck, 225mm Race Clutch Disc is intended for use with the 1987-91 TURBO II gear box, with the larger diameter 23 tooth input shaft, mated to a 225mm flywheel--is designed for drag and road race use. The disc incorporates four (4) sintered copper pucks and a rigid hub for quick, positive engagement, greater fatigue resistance and improved heat dissipation. The sharpened engagement/disengagement characteristics of this disc require careful driver attention - this disc is not intended for street use.
As with all of our clutch products, it is built only from new parts.

Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage. (See bottom of parts list).

WARNING: None of the Flywheel or Clutch components shown in this catalog should ever be allowed to exceed 10,500 RPM under any condition. This same RPM limit applies to stock components. You must use an engine RPM-limiter to prevent excessive RPM. If your engine is capable of exceeding 8,500 RPM you must install a transmission scatter shield, or ballistic blanket. Failure to implement the above may result in serious injury or even death.

Go to Racing Beat Home Page
Select: Go to Shopping Cart