1986-92 Mazda RX-7 Performance Parts : Clutch/Pressure Plate

 : Clutch/Pressure Plate : Race Disc - 225mm 6-Puck TURBO Hub Spline

Race Disc - 225mm 6-Puck
TURBO Hub Spline

Part Number: 12527

Price: $170.00

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

Race Disc - 225mm 6-Puck
TURBO Hub Spline

This special application 6-Puck, 225mm Race Clutch Disc-- intended for use with the 1987-91 TURBO II gear box, with the larger diameter 23 tooth input shaft, mated to a 225mm flywheel--is designed for drag and road race use. The disc incorporates six (6) sintered copper pucks and a rigid hub for quick, positive engagement, greater fatigue resistance and improved heat dissipation. The sharpened engagement/disengagement characteristics of this disc require careful driver attention - this disc is not intended for street use.

As with all of our clutch products, it is built only from new parts.

Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage. (See bottom of parts list).

WARNING: None of the Flywheel or Clutch components shown in this catalog should ever be allowed to exceed 10,500 RPM under any condition. This same RPM limit applies to stock components. You must use an engine RPM-limiter to prevent excessive RPM. If your engine is capable of exceeding 8,500 RPM you must install a transmission scatter shield, or ballistic blanket. Failure to implement the above may result in serious injury or even death.

Customers who bought the above item also often bought:

Transmission Throwout Bearing - 87-88 TURBO II

Transmission Throwout Bearing - 87-88 TURBO II

The original throwout bearing normally does not require replacement unless it has been abused in some way. However, if it has been making noise, such as a whirring sound when the clutch pedal is depressed, or if the slave linkage has run out of clearance,... Transmission Throwout Bearing - 87-88 TURBO II

Stainless Steel Clutch Line - 86-92 RX-7

Stainless Steel Clutch Line - 86-92 RX-7

Replace the original rubber clutch line on your 1986-92 RX-7 chassis with an upgraded braided stainless steel line. Can be used for both street and race applications. Stainless Steel Clutch Line - 86-92 RX-7

Racing Beat License Plate Frame

Racing Beat License Plate Frame

This Racing Beat logo license plate frame will look good on any Mazda vehicle! Constructed from heavy gauge plastic, this economical plate frame is the perfect addition to your vehicle. Racing Beat License Plate Frame

Street/Strip Pressure Plate - 87-91 TURBO II

Street/Strip Pressure Plate - 87-91 TURBO II

The 1987-91 TURBO II High Performance Pressure Plate provides excellent clamping force to significantly reduce slipping. Manufactured from all new parts, this pressure plate interchanges exactly with the stock unit. Time Saving Tip: We strongly... Street/Strip Pressure Plate - 87-91 TURBO II

Go to Racing Beat Home Page
Select: Go to Shopping Cart