Mazda RX-8 Performance Parts : Clutch/Pressure Plate

 : Clutch/Pressure Plate : Sport/Race Disc -6 Puck 87-95 RX-7 Turbo & RX-8

Sport/Race Disc -6 Puck
87-95 RX-7 Turbo & RX-8

Part Number: 12523

Price: $176.00

Qty:

Addtional Photos - Select to Enlarge

Facebook Share

Sport/Race Disc -6 Puck
87-95 RX-7 Turbo & RX-8

The 6-Puck 240mm Sport/Race Clutch Disc for the 1987-95 RX-7 TURBO & RX-8 chassis is designed for road race and occasional drag race use. The disc features six (6) sintered copper pucks and a sprung hub for a quick, positive engagement. The quick engagement/disengagement requires careful driver attention - this disc is not recommended for street use. This disc interchanges exactly with the stock disc and can be used with the stock pressure plate.

As with all of our clutch products, it is built only from new parts.

Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage.

WARNING: None of the Flywheel or Clutch components shown in this catalog should ever be allowed to exceed 10,500 RPM under any condition. This same RPM limit applies to stock components. You must use an engine RPM-limiter to prevent excessive RPM. If your RX-7 engine is capable of exceeding 8,500 RPM (or 9,000 RPM for the RX-8 Renesis engine) you must install a transmission scatter shield, or ballistic blanket. Failure to implement the above may result in serious injury or even death.

Customers who bought the above item also often bought:

Street/Strip Pressure Plate - 87-91 TURBO II

Street/Strip Pressure Plate - 87-91 TURBO II

The 1987-91 TURBO II High Performance Pressure Plate provides excellent clamping force to significantly reduce slipping. Manufactured from all new parts, this pressure plate interchanges exactly with the stock unit.

Time Saving Tip: We... Street/Strip Pressure Plate - 87-91 TURBO II

Transmission Seal Kit - 87-88 TURBO II

Transmission Seal Kit - 87-88 TURBO II

We recommend replacing the transmission front seal and rear seal kit when re-installing the transmission to reduce the risk of leakage. The primary reason for leaks seems to be the large loads that are placed on the input shaft when re-installing... Transmission Seal Kit - 87-88 TURBO II

Gasket/O-Ring Kit - 87-88 13B Turbo Engines

Gasket/O-Ring Kit - 87-88 13B Turbo Engines

Racing Beat offers a complete gasket and O-ring kit for use on all 1987-88 13B turbo rotary engines.

Determining all of the correct components that are required to rebuild a rotary engine can be a time consuming task. Forget or over look... Gasket/O-Ring Kit - 87-88 13B Turbo Engines

Go to Racing Beat Home Page
Select: Go to Shopping Cart