Early Rotary & 1979-85 Mazda RX-7 : Clutch/Pressure Plate

 : Clutch/Pressure Plate : Race 4-Puck Disc Turbo II Hub Spline - 225mm OD

Race 4-Puck Disc
Turbo II Hub Spline - 225mm OD

Part Number: 12525

Price: $267.75

Qty:

Addtional Photos - Select to Enlarge

Race 4-Puck Disc
Turbo II Hub Spline - 225mm OD

This special application 4-Puck, 225mm OD Race Clutch Disc is intended for use with the 1987-91 RX-7 TURBO II gear box, utilizing the larger diameter 23 tooth input shaft, mated to a 225mm OD flywheel and pressure plate. The disc incorporates four (4) sintered copper pucks and a rigid hub for quick, positive engagement, greater fatigue resistance and improved heat dissipation. The sharpened engagement/disengagement characteristics of this disc require careful driver attention - this disc is not intended for street use.

Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage. (See bottom of parts list).

Safety Note: None of the Racing Beat, Exedy, Mazda OE, or any aftermarket flywheel or clutch replacement components should ever be allowed to exceed 10,500 RPM under any condition. You must use an engine RPM-limiter to prevent excessive RPM. If your engine is capable of exceeding 8,500 RPM you must install a transmission scatter shield or ballistic blanket. Failure to implement the above may result in serious injury or even death.

Prop65Warning

Customers who bought the above item also often bought:

Aluminum Main Pulley - Double Sheave - 74-92 Rotary Engines (All)

Aluminum Main Pulley - Double Sheave - 74-92 Rotary Engines (All)

Racing Beat Aluminum Double Sheave Main Drive Pulley Intended for virtually all 1974-92 12A and 13B rotary engines, the Racing Beat main drive pulley is designed for high performance/RPM street and moderate racing use, slowing the water pump and... »more
Price: $112.79 ADD »

Oil Line Set - 1986-92 RX-7 All

Oil Line Set - 1986-92 RX-7 All

Racing Beat's fully assembled Stainless Steel Oil Cooler Hose Sets for the 1986-1992 RX-7 TURBO II and Non-Turbo chassis replace the original factory RX-7 oil cooler hoses. Significantly less costly than the Mazda replacement RX-7 oil lines, the... »more
Price: $327.44 ADD »

Fuel Injection Plug Kit - 84-92 RX-7

Fuel Injection Plug Kit - 84-92 RX-7

Designed by Racing Beat, this kit comes complete with machined fuel injector plugs, O-rings, Allen head bolts, and a retention plate. The Fuel Injection Plug Kit fits all 1984-92 13B 6-Port and 1987-91 TURBO II engines and is intended for use when... »more
Price: $72.77 ADD »

Muffler Tip - 3-inch Inlet - Universal - Double-wall Round - Angle Tip

Muffler Tip - 3-inch Inlet - Universal - Double-wall Round - Angle Tip

Racing Beat Universal Muffler Exhaust Tip We offer this universal muffler tip (3.05" inlet diameter) for use in the construction of your own custom exhaust system.The specifications are as follows: - Overall length: 170mm (6.7") -...
Price: $69.13 MORE INFO »

Go to Racing Beat Home Page
Select: Go to Shopping Cart