
Early Rotary & 1979-85 Mazda RX-7 : Clutch/Pressure Plate
Racing Beat Recommended Accessories:

Transmission Throwout Bearing - Pre-79 12A & 13B
The original throwout bearing normally does not require replacement unless it has been abused in some way. However, if it has been making noise, such as a whirring sound when the clutch pedal is depressed, or if the slave linkage has run out of clearance,... »more
Price: $45.00 ADD »

Transmission Throwout Bearing - 79-88 - 12A & 13B 6 Port
The original throwout bearing normally does not require replacement unless it has been abused in some way. However, if it has been making noise, such as a whirring sound when the clutch pedal is depressed, or if the slave linkage has run out of clearance,... »more
Price: $40.94 ADD »

Flywheel Nut Wrench Tool
Having the correct tool always makes the job seem easy, right? Although you probably won't be using this tool much, it will certainly pay for itself even if you only use it once! The Flywheel Nut Wrench tool is used to remove or install the... »more
Price: $58.21 ADD »

Flywheel Stopper Bar Tool
The Flywheel Stopper Bar Tool is normally required whenever the rotary engine flywheel retaining nut is being removed or installed. The Racing Beat Stopper Bar bolts to either the stock flywheel, the Racing Beat Flywheel, or equivalent (except Tilton) and... »more
Price: $38.81 ADD »

Stock Flywheel Puller Tool
The Stock Flywheel Puller Tool will remove any stock Mazda flywheel from its taper press fit on the eccentric shaft once the flywheel nut is loosened. This easy-to-use tool is a "must have" for any serious rotary mechanic!
»more
Price: $58.21 ADD »