Road Race Presilencer - Stainless Steel
86-92 RX-7 *

Part Number: 16448

Price: $339.57

See below for special ordering options
and instructions.

Addtional Photos - Select to Enlarge

Road Race Presilencer - Stainless Steel
86-92 RX-7 *

Instruction Manual

Racing Beat's Road Race Stainless Steel Presilencer for the 1986-92 RX-7 is intended to bolt-up to the dual outlet of the Road Race RX-7 Header. This fully stainless steel presilencer has been especially designed to function with the Road Race header to offer a "true" dual primary exhaust system for the 1986-92 RX-7. The outlet end of this RX-7 presilencer section is intended to bolt-up to the inlet of the Road Race Y-pipe section.

This Presilencer unit is equipped with dual stainless steel 2" OD tubes, presilencer canister, mounting hangers, and attachment flanges. This unit incorporates the factory hanger positions and comes complete with outlet gasket and (6) mounting bolts/nuts. This unit weighs 24 lbs and is approximately 34" in length.

Racing Beat Note: If you have located this part from the parts listing on the drop-down menu, we suggest you review the information on the introduction page for the RX-7 Road Race Exhaust System. This page provides details on the components for your exact application and serves as a useful "starting point" when building your exhaust system. For an overview of the Road Race Exhaust System, click here.

Replacement Rubber Exhaust Hangers
We recommend the replacement of the original RX-7 rubber exhaust hangers during the installation of any new exhaust component. It is our experience that over time the original rubber hangers can deteriorate, crack, and fail; which can result in the incorrect alignment of the exhaust system.

We offer replacement exhaust hangers for all models of 1986-92 RX-7's. Review the Exhaust Hanger Chart for details on the exact components that are required for your exhaust system.

Made in the USA by Racing Beat, LLC.