Price: $358.05

Racing Beat's fully assembled Stainless Steel Braided Hose Set replaces the original factory oil cooler hoses on the 2004-08 RX-8 Automatic Transmission models. Intended for use on RX-8 models equipped with only ONE factory-installed oil cooler on the driver's side of the vehicle.

Costing much less than Mazda replacement units, the Racing Beat Oil Hose sets will meet the demands of both street and race. Simplify your oil line system by replacing the original FOUR (4) factory lines with the streamlined Racing Beat kit, which contains only two (2) lines.

The Mazda factory lines combine both rigid and flexible tubing, and include two (2) mid-hose connector fittings. Replacing this combination of hosing and connectors with a simplified performance-based set eliminates possible areas of leakage during racing and high output applications. As the old saying goes, "Simple is better!" Produced in-house at Racing Beat using Earl's Auto-Flex stainless steel braid-protected synthetic rubber hose and featuring an inner liner of synthetic rubber, including partial cover of stainless steel braid embedded into the liner during manufacturing. The hose liner is then bonded to a outer protective sheath of stainless steel wire braid. Precision-machined aluminum Earl's Auto-Seal and Swivel-Seal hose ends ensure a secure and superior seal. Each line is pressure tested by Racing Beat at the end of the assembly process.

Unlike earlier rotary applications, replacement of the oil lines on the RX-8 application requires substantial labor effort and is best undertaken when the engine has been removed from the vehicle. Although more challenging due to limited access, this project can be undertaken with engine in the vehicle, just allow adequate time to complete the process. With the engine in the vehicle this is an involved project that can't be rushed!

Shipped complete with all required oil lines, oil cooler adaptors, engine adaptors, bracket hardware, protective end caps, and fully detailed installation instructions.